; simple usb configration added by simpleusb-config.sh
;  2019.08.12.0800

[general]

[usb]

; Alinco DR135, DR235, DR435 Transceivers


eeprom=0
			; 1 = Indicates that an EEPROM internal to the radio
			;     adapter and cable is expected. 
			; 0 = no warning message if no EEPROM found.

rxboost=0
			; Rx Audio Boost
			; 0 = 20db attenuator inserted 
			; 1 = 20db attenuator removed
			; Set to 1 for additonal gain if using a low-level
			; receiver output.

carrierfrom=usb
			; Options - no,usb,usbinvert 
			; no - no carrier detection at all
			; usb - via USB radio adapter COR connection
			; usbinvert - same as above but inverted polarity.

ctcssfrom=no
			; CTCSS Decoder Source
			; Options = no,usb,dsp
			; no - CTCSS decoding, system will be carrier squelch
			; usb - CTCSS decoding using input from USB adapter 
			; usbinvert - same as above but inverted polarity.

invertptt=0
			; Invert PTT 0 = ground to transmit, 1 = open to
                        ; transmit
 
                        ; This is the collector lead of the 2n4401 on the 
                        ; modified usb sound fob.

plfilter=yes
			; enable PL filter
			; yes, enabled
			; no, disabled

deemphasis=yes
			; enable de-emphasis (input from discriminator)
			; yes, enabled
			; no, disabled

preemphasis=no
			; enable pre-emphasis (output to Tx)
			; yes, enabled
			; no, disabled

rxaudiodelay=0
			; default value is 0
			; rx audio delay for squelch tail elimination.
			; Squelch tail delay in 20ms frames. Values range
			; from  0 (no delay) to 24 (480ms delay)
			; Typical values would range from 5-10 (100-200ms)

plfilter=yes
dcsfilter = no
rxondelay = 0
queuesize = 8
tx_audio_level_method = 0

; EOF